From what it appears above your internal hosts are on subnet 192.168.2.60 with a 30 bit mask. This only gives you two addressable hosts. Use the following
Inside host network: 192.168.2.0/25
Router A-B 192.168.2.240/30
As you can see this is quite messy especially if using DHCP without VLAN's and dividing the secondaries amongst subinterfaces. Personally I would use an entire class C for the hosts being that you have 230 of them. And a seperate 30 bit subnet for the router link. Your using a private addressing scheme so this should not be a problem for you.
From what you're discribing. You currently have 2 Routers; Router A (192.168.2.42/30) and Router B (192.168.2.41/30). If you have 230 host on one subnet a /24 mask is required. For this you can use Private Network addresses say, 192.168.20.0/24.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.