This server has one NIC card connected to a switchport. However, it is running Vmware software to enable it to run multiple virtual server in it. Customer would like to create multiple logical Ip address that bind to only one physical Ethernet interface. On the switchport, shall I configure it as an access port and bind to only one VLAN or configure it as a trunk port and allow the VLAN that the virtual server ip subnet they belong to.
Is the intent here to allow the server to participate in multiple subnets? If so, as long as the NIC supports 802.1q, the best method here is to configure the switchport as a trunk.
If not, I'm not sure what other options are available. If you configure the switchport as a standard access port, only the IP address that is in the same VLAN/subnet as the switchport will be able to communicate properly.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...