I currently manage a small frame-relay network (5 sites) using VOFR. No subinterfaces are currently used. I want to configure subinterfaces - there is a partial mesh. I'd like to know what dial-peer statements should change when I use the subinterfaces, if any. For instance, a current dial-peer statements map to Serial0/0, DLCI 100. When I add the subinterface, should the dial-peer point to Serial0/0.100, Serial0/0.100 DLCI 100, or keep the Serial0/0 DLCI 100 mapping. I may need to clarify, but thanks for any help in advance.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.