Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Voice and Data Integration

I have a Full T1 from Telco and want to split channels between voice and data. 12 channels would be for the data and 12 for the voice. I need some help with the configuration of 2620-XM router.

1)What kind of WIC card I would need? I believe, I will need (2) physical ports one for the telco and the other one for cross connecting to the PBX. Can these (2) be on the same WIC Card or I will have to use to (2) different slots for each connections.

2)How do I break down channels in IOS to making sure 12 goes to the data and the other 12 goes to the voice.

I tried CCO link, but didn't find any related info.

Thanks in advance.

Asghar.

1 REPLY
New Member

Re: Voice and Data Integration

You are looking for a VWIC-2MFT-T1-DI. Two T1 ports with Drop and Insert for cross connecting TDM channels.

Here is a sample config with channels 1-12 for data and 13-24 for voice:

controller T1 0/0 (To Network)

framing esf

linecode b8zs

channel-group 0 timeslots 1-12 speed 64

(creates int ser 0/0:0)

tdm-group 1 timeslots 13-24 type e&m

description T1 circuit from Provider

!

controller T1 0/1 (To PBX)

framing esf

clock source internal

linecode b8zs

tdm-group 2 timeslots 13-24 type e&m

connect tdm1 T1 0/0 1 T1 0/1 2 (connects the tdm groups for voice to the PBX)

interface serial 0/0:0

(Enter data configuration here)

The cable used between your router and PBX may need to be a T1 crossover.

Mark

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800f9d37.shtml

148
Views
0
Helpful
1
Replies
CreatePlease login to create content