I was wondering if anyone here knew how to monitor the utilization on a NMHDVT1 Voice Card for a 3640. Someone in the VoIP discussion group gave me good SNMP variable for an AS5300 that show the DS0's currently in use, and the DSO peak, but the MIB OID's didn't work on the 3640.. Any idea on how I can track the trunk usage?
This is most likely due to the fact that the CISCO-POP-MGMT MIB is not present in the IOS that you're running, atleast not in 12.1(5) and may very well be CSCdt54030/CSCdt51985. (See CCO Bug Toolkit for details). You can use http://www.cisco.com/go/mibs to verify whether this MIB is present in 12.1(5)XM4 or not (most likey it is not). You can also use this automated list to find out whether this IOS image has this particular MIB present or not. Send email to email@example.com with a subject of "help" to find out how. (Note: this is an automated list). On the router CLI, you can also do a 'show snmp mib' command to see if you get the above OIDs in the list or not (which I doubdt). Hope this helps.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...