Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

ftr
New Member

VP SHAPING ATM 6400 NSP

I have a cisco 6400 with oc3 (stm-1).

There are aprox 190 VP's active and 1000 VC's being distributed from atm 8/0/0 to atm 1/0/0, 2/0/0, 3/0/0 and so on. My question is how can I make transmit shaping to the metro network on the VP in the atm 8/0/0?? Should I have a LS1010 infront for te shaping to take place?

Please advice.

Fabian

2 REPLIES
Bronze

Re: VP SHAPING ATM 6400 NSP

New Member

Re: VP SHAPING ATM 6400 NSP

If you have CCO account, you may search for the VP shaping configuration. We have a lot doc ragarding this.

Here is one of them:

http://www.cisco.com/en/US/partner/tech/tk39/tk371/technologies_tech_note09186a00800d79b3.shtml

Regards.

bessie

124
Views
0
Helpful
2
Replies