Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

vpdn l2tp virtual-access 3.?

hello,

we have a few 2620's running as LNS with VPDN L2TP setup. We can dial in and get assigned IP etc. ping the local LNS, but nothing else. We have recenlty upgraded from 12.2(11)T2 to 12.2(15)T5. Configuration is the same. I noticed between the two different versions we get different Virtual-Access interfaces. Working LNS assigns the expected sequential numbering; virtual-access1, virtual-access2, etc. But the new IOS lists virtual-access3.1, as if this is some sort of sub-interface. Has anyone come accross this situation?

Also, the "Mode" on new version is listed as PPPoVPDN, while old version lists PPP(L2TP). I'm assuming these two are related?

thanks

1 REPLY
Bronze

Re: vpdn l2tp virtual-access 3.?

I see that virtual-access sub-interface is a new feature introduced in 12.2(13)T . This one should give you more information :

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a00800f4b47.html

191
Views
0
Helpful
1
Replies