Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPDN (routing dialup)

Hi

We are using VPDN with L2TP tunnels terminated on 7200 routers. Each router has its own address pool. However, some dialup customers ask for static IP addresses. I don't know to which L2TP router they will connect.

I am using ISIS between these routers and the rest of our network.

Since I am excluding the static IPs subnet from the ISIS announcemnet, I had to announce them as "connected" .

This will disturb the routing table with frequent triggered updates b/c of the connection/disconnection of the dialup.

Am I doing the right thing or is there a better solution.

  • Other Network Infrastructure Subjects
1 REPLY

Re: VPDN (routing dialup)

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

87
Views
0
Helpful
1
Replies
This widget could not be displayed.