cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
388
Views
0
Helpful
1
Replies

VPS - speed and duplex settings on a Catalyst

srooplal
Level 1
Level 1

What is the correct speed and duplex settings for a VPS connecting to a Catalyst 4006 - is it 10/half , 10/full , 100/half ,100/full or auto. We installed the network and had major issues with it set to 100/full - we changed to auto and have no issues. According to Cisco best practice , all ports should be manually set and not to auto

1 Accepted Solution

Accepted Solutions

Prashanth Krishnappa
Cisco Employee
Cisco Employee

Our best practice is not to hard code

http://www.cisco.com/warp/public/473/103.html#subfirstthree

We suggest hardcoding only if the link partner has issues with auto-negotiating. Since you are not having any issues, I suggest you leave it at auto-negotiate

View solution in original post

1 Reply 1

Prashanth Krishnappa
Cisco Employee
Cisco Employee

Our best practice is not to hard code

http://www.cisco.com/warp/public/473/103.html#subfirstthree

We suggest hardcoding only if the link partner has issues with auto-negotiating. Since you are not having any issues, I suggest you leave it at auto-negotiate

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco