i think you can do it but not sure...we can put logic like on the far end you need to creat the two tunnel interface...one interface will connect with the VRRP active router and other will connected with the STANDBY router...so normally the tunnel between far end and active router will use and the tunnel between standby and far end router will remain ideal it will be in used then only if the active router will down...so at far end you have to configure such that normally path through the active router will come in to the routing table when the active router is in working...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...