Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VRRP on Catalyst 4500-SUP4?

As far as I can understand it our Catalyst 4500:s with 12.113)EW IOS doesn't support VRRP but only HSRP.

Do you think that VRRP will ever come to theese or is it more used with ordinary routers? Is VRRP considered better than HSRP except that it HSRP is Ciscoproprietary?

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: VRRP on Catalyst 4500-SUP4?

Sorry but VRRP is not supported for this hardware at this point but hsrp is .

3 REPLIES
New Member

Re: VRRP on Catalyst 4500-SUP4?

My guess is that Cisco may not port it for this hardware. As far as I know, both HSRP and VRRP serve the same purpose although I am not sure about finer details. All I know is to use VRRP when you have non cisco devices in the network.

Bronze

Re: VRRP on Catalyst 4500-SUP4?

Sorry but VRRP is not supported for this hardware at this point but hsrp is .

New Member

Re: VRRP on Catalyst 4500-SUP4?

My experience is more w/ dual msfcII in 6500 and I run

them in single-router-mode. Can you verify for me that

I won't be stuck running HSRP in a redundant 4507

configuration? SInce the secondary supervisor is only

partially booted does this mean all layer 3 interfaces on

the secondary supervisor are shutdown until switchover occurs?

Thanks very much. Larry

483
Views
0
Helpful
3
Replies
CreatePlease to create content