Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VTP Configuration Revision Number

I want to know if we can set an specific number for the VTP Configuration Number.

Any undocumented command ?

5 REPLIES
Purple

Re: VTP Configuration Revision Number

not that I know of , it starts at 0 and then increments by 1 everytime it gets changed. Why would you need to put a specific revision number in ?

New Member

Re: VTP Configuration Revision Number

Thanks for your time, I am teching BCMSN and an student mentioned it could be done but he did not remember how to do it, and I want to confirm that the only way to modify such a value is changing to Transparent or reconfiguring the domain.

Bronze

Re: VTP Configuration Revision Number

in regards to the changing of the mode to transparent, what i meant was change it to transparent mode to get it to zero, then change it back to the original vtp domain name. that will do the trick.

New Member

Re: VTP Configuration Revision Number

You can reset it to zero by changing the vtp domain name. Like Glen said, it increases by changing then vlan database. As far as I know you can't set a specific value, but you can do it step-by-step by adding/deleting vlans until you have the value you wanted.

More info:

http://www.cisco.com/warp/public/473/vtp_flash/

Bronze

Re: VTP Configuration Revision Number

well, to add in to the changing of vtp domain name method, u can change the mode to transparent to get the config rev. back to zero.

138
Views
0
Helpful
5
Replies