I have couple switches setup in VTP server mode. All of them have the same VTP revision number, but most of them should be in VTP client mode.
Will switching some of them (but the one I really want to have in VTP server mode) into VTP client mode have negative impact on the network? I do know that if you change a switch (with the highest rev #) from client mode to server mode I could end up with problems. However, in my case it will be switching them from server to client mode with all of them with the same Rev #.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...