Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VTP password deployment

I have already deployed 100s of 2924s all over the campus. VTP domain info is configured without password.

How can I modify VTP info to include password security globaly (without going to every single switch individually)?

Is there any place in CiscoWorks that this could be done?

I appreciate all suggestions.

Senad Palislamovic

Network Specialist

WSU

Ogden, UT 84403

spalislam@weber.edu

1 REPLY
New Member

Re: VTP password deployment

Per Cisco documentation, if you configure VTP in secure mode, the management domain will not function properly if you do not assign a management domain password to each switch in the domain. However, I am not sure if Ciscoworks has that functionality.

Please refer the following URL:

www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_6_1/config/vtp.htm

81
Views
0
Helpful
1
Replies