Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VTP Pruning

I was wondering what is the amount of time it takes a vtp client to change it's vtp pruning mode to enable. I have just configured a new 3548xl in my vtp domain and it seemed like it took awhile to change to vtp pruning enable.

2 REPLIES

Re: VTP Pruning

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Purple

Re: VTP Pruning

It can take a little while depending on how many vlans you are actually pruning off . It can take 2-3 minutes for a large number of vlans to be pruned .

111
Views
0
Helpful
2
Replies