Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VTP Prunning Betwen VTP Clients

i have the following VTP Domain scenario, and i want to configure VTP Prunning for clearing some Vlans .

This configuration is in the 2 Clients.

Can configure Prunning in this 2 client???/

or i need to make this configuration in the VTP Server????

-----=====-------======--------

Server Client Client

4 REPLIES
Purple

Re: VTP Prunning Betwen VTP Clients

You make them on the server if you are using the server,client scenario .

New Member

Re: VTP Prunning Betwen VTP Clients

But i don't want to configure the Server.

I only want to prune a trunk link Betwen 2 Clients.

Can i make this configuration Without configure the server???

Re: VTP Prunning Betwen VTP Clients

I will answer this for the sake of future visits on this thread:

In order to enable VTP prunning you need to enable it on only one VTP server (works for VTP v1, v2) or on EACH VTP server switch if you run VTP v3.

This is aplicable for a single VTP domain.

New Member

Re: VTP Prunning Betwen VTP Clients

Hi,

If you don't want vlan traffic to cross between the clients you can allow the vlans on the trunk:

switchport trunk [allow/pruning] vlan xxx,xxx,xxx

Hope this helps

221
Views
0
Helpful
4
Replies