I am configuring a switch prior to deploying it to the closet of course and settting up the ports for there correct VLANS. The switch is setup in client mode for VTP so only VLAN one exists on the switch. When I assign a specific port to a different VLAN other then 1 the port is assigned and then an error is message is given because the client is not attached to the VTP domain. My question is once the switch is introduced to the domain will the port remain on the VLAN that I assigned such as 104 or will it default to VLAN 1?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...