Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VTP

Is there is any way to prune a specific vlan for a specific time.

If I set the mac-address-table aging time for a specific vlan

will it going to acheive the above requirement.

Thks

1 REPLY
Silver

Re: VTP

IF you are referring to time-based VTP pruning then no.. It's not supported. Either that vlan is cleared or its not. If you change the aging time of the mac table for that VLAN it would not clear it from your trunks but merely flood traffic to all ports in your VLAN when your MAC addrs were aged out to repopulate the CAM.

Hope this helps you,

Don

78
Views
0
Helpful
1
Replies
CreatePlease to create content