I had a 2950 connected to a 6509. The 6509 was the vtp server and the 2950 was the vtp client. Vlans were learned and all was well. I later had to connect the 2950 to another 6509 - which was a different vtp domain. I thought it would automatically discover the new vtp domain, vlans, etc. but it didn't. Did I simply need to wait longer or is there a commnd that can be run to force the switch to rediscover its vtp information?
The only solution i had was to hard-code the vtp domain name.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...