Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

vWIC-1MFT-G703

I need to use this VWIC above only for data, but I have to use interface G.703 clocked at 64Kbps ( no 2 Mbps).

Does it make sense ?

1 REPLY
Bronze

Re: vWIC-1MFT-G703

The VWIC-1MFT-G703 can be used for data calls in the following cases:

- When the Multi-Flex Trunk is used in the WIC slot of the 2600, the E1 can be configured into a single channel group as a serial interface (64k is fine).

- Same goes for the 3600 NM-1E2W, NM-1E1R2W, NM-2E2W, NM-1FE2W, NM-1FE1R2W, NM-2FE2W, and NM-2W (again, 64k is fine).

226
Views
0
Helpful
1
Replies
CreatePlease to create content