Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VWIC-2MFT-T1 MIb issue

polling the card I see the interface operational stauts for Serial0/0:0 and Serial0/1:0 as unknown. I see the T10/0 and T10/1 as up. Used both old and new Cisco MIBs. Currently using Solarwinds Orion to try and monitor a Cisco 2691with a VWIC-2MFT-t1 card in it.

1 REPLY
New Member

Re: VWIC-2MFT-T1 MIb issue

Are you trying to use the ifEntry mib table? It should provide entries for each interface on a device. The ifEntry.ifDescr or ifXEntry.ifName variable should give you a human readable name for that entry.

Cheers!

Jim

91
Views
0
Helpful
1
Replies