Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

vwic config on 2600

I am setting up a 2600 series with 2 vwics for 4 T1 lines. How do I configure it to connect to older 2600s with T1 wics on the other end. The old ones are interface serial(#) and these are controller T1 (#)

Please E-mail me if you have any info admin@goitc.net

Thanks

1 REPLY

Re: vwic config on 2600

you will need to have an external CSU DSU for those 2600s with serial interfaces. The controller T1 corresponds to the T1 controller on the wics which has inbuilt CSU/DSU

85
Views
0
Helpful
1
Replies