In the past, I have connected two routers between T1 Controllers using the clock source as internal on one of them to route traffic. At this time I have a lab situtation that needs connectivity between 2 routers and the only ports I have available are a T1 controller on one router, and an E1 controller on the other router. Is it possible to connect these 2 controllers together to and get routing between them?
There is no direct way to connect T1 to E1 controllers back to back. But yo can find some simulator which can give you T1 line at one end and E1 line at other end and dial from one to other to get connectivity.
But there is no direct way to connect back to back.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...