Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAN INTERFACE GETS HUNG

Friends

I am maintaining a good number of sites running on OSPF. Recently I have started facing strange problem. My one of the site has got 2 x 2 mbps links. Earleir my both links were working fine . Nowadays one of the link I can't ping from the router where it is attached but can ping it from my RAS. But when I used extended ping on the router with timeout 1205, I get response (without any packet loss). So I thought PORT is faulty and I changed the port. But whenever I change the port it works fine for 1 or 2 days but later on again same position. I am unable to identify the cause . Though I used "clear counter" and "clear ip ospf redistribution" for the interface but all efforts are in vain. The strange part is this my other routers are getting OSPF updates from both of the links.

Please advice ASAP .. Its urgent.

Thanx in advance

1 REPLY
New Member

Re: WAN INTERFACE GETS HUNG

If raising the timeout value allows a ping to go through, do a show interface and ensure you aren’t experiencing a high amount of traffic. Clear counters, monitor closely, you may be getting very bursty traffic, which degrades performance intermittently.

104
Views
0
Helpful
1
Replies