You can use any ip addressing schem within your private network (frame-relay, isdn, lan). At HQwest make sure that you configure nat so that the private address is translated to the public IP assigned to you.
On the ISDN link and Frame-relay link you can use one subnet each with a /30 mask (since only 2 host addresses are required).
You will need 3 class Cs for each of the LAN at west, south, and east. (/24 mask). You can choose this from the private RFC1918 address space. (10,172.16 or 192.168). On the wan links you can use a subnet with 2 hosts (/30 mask).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...