Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Wan link Configure Ciscoworks.

I was asked to add 6509 switch in ciscoworks.

when I tried to add the device the device is shown as not responding.

The device is connected to my site through a wan link

I am able to ping and trace.

What could be the problem

regards,

shashank

2 REPLIES
Blue

Re: Wan link Configure Ciscoworks.

Select the device and under Device Actions select show details to check what is the Not Responding Reason in RME.

New Member

Re: Wan link Configure Ciscoworks.

Since it is a WAN link you would not want to have CDP enabled on the interface facing the WAN. Also being a WAN link your service provider is definitely not going to pass through those cdp advertisements. You would need to enter the device manually in your seed file for it to be discoverd.

Server Config > AniServer admin > discovery settings > add seed device, or alternately you could go to your CSCO partition > /etc/cwsi/aniserver.prop file and manually enter in the device where it says Discovery Seed = ..

106
Views
0
Helpful
2
Replies