WAN Router won't Ping or connect to Internet PIX box
I have a T1-WAN offsite connected via a 2500 router to my main router 2611 home. I also have a PIX for Internet access on the home network. When comming thru the 2500 offsite I can't see the PIX. I can't even ping the PIX even from inside the 2500. I can access the internet thru my Proxy server fine from offsite thru 2500.
Re: WAN Router won't Ping or connect to Internet PIX box
Assuming that there is a valid route from the 2500 to the PIX, check the PIX configuration to see if telnet access to it is allowed from 2500 ip address or subnet. Also, by default, the PIX will not pass or reply to ICMP echo requests (ping) unless it is explicitely configured to do so.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...