Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAN simulation with 2 wic t1 cards w-csu/dsu

If I have 2 2600's with wic t1 cards can I simulate a 512k leased line between the 2 with the proper configurations? if so what are the commands and to use a straight through or x-over cable?

3 REPLIES
New Member

Re: WAN simulation with 2 wic t1 cards w-csu/dsu

You can get a router - to - router serial cable. Here is who I used.

http://www.stonewallcable.com/dept.asp?dept_id=10

New Member

Re: WAN simulation with 2 wic t1 cards w-csu/dsu

That's not the problem I can get the rtr back-to-back no problem just want to recreate 512 or 256 bw on the 2600

New Member

Re: WAN simulation with 2 wic t1 cards w-csu/dsu

You just need to use a x-over between the T-1 interfaces, set one router to supply the T-1 clock, and set both interfaces to use the channels you want. For 512k you'd use "service-module T1 timeslots 1-8" at the serial interface config.

255
Views
0
Helpful
3
Replies
CreatePlease login to create content