06-17-2012 09:01 PM - edited 03-03-2019 06:38 AM
I am trying to setup WCCP on our 4507. For some reason I cannot get this to work! The config I have tried is below. I can't figure out what I'm doing wrong here!
ip wccp web-cache group-list IRONPORT-GROUPLIST
ip wccp source-interface GigabitEthernet2/24
!
Interface Vlan160
ip address 10.10.16.1 255.255.254.0
ip wccp web-cache redirect out
!
ip access-list IRONPORT-GROUPLIST
permit ip any host 10.11.1.10 (10.11.1.10 is the ironport proxy IP address)
On the ironport I setup web-cache under transparent redirection and provided the IP address I used to source from above (GigabitEthernet2/24). Here is the output I get on the 4507:
10CSW-LAN1#sh ip wccp web-cache
Global WCCP information:
Router information:
Router Identifier: 10.11.1.9
Configured source-interface: GigabitEthernet2/24
Protocol Version: 2.0
Service Identifier: web-cache
Number of Service Group Clients: 1
Number of Service Group Routers: 1
Total Packets Redirected: 0
Process: 0
CEF: 0
Platform: 0
Service mode: Open
Service Access-list: -none-
Total Packets Dropped Closed: 0
Redirect access-list: -none-
Total Packets Denied Redirect: 0
Total Packets Unassigned: 0
Group access-list: IRONPORT_GROUPLIST
Total Messages Denied to Group: 0
Total Authentication failures: 0
Total GRE Bypassed Packets Received: 0
Process: 0
CEF: 0
Platform: 0
Here is the debug output:
2w3d: WCCP-EVNT:Process: Start V2 (138)
2w3d: WCCP-EVNT:Successfully opened UDP socket
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:router-id set (initialise) 0.0.0.0 => 10.11.1.9
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: allocate wc orig mask info (540 bytes)
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:1
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: reuse wc orig mask info (540 bytes)
2w3d: WCCP-EVNT:S0: HIA from 10.11.1.10 updated transmit interval to: 10000
2w3d: WCCP-EVNT:S0: HIA from 10.11.1.10 updated timer scaling factors to: 1 and 1
2w3d: WCCP-EVNT:S0: HIA from 10.11.1.10 updating group methods
2w3d: WCCP-EVNT:S0: HIA from 10.11.1.10 updating group timers
2w3d: WCCP-EVNT:S0: no srvc grp mask data to validate
2w3d: WCCP-EVNT:S0: created adjacency interest, 10.11.1.10
2w3d: WCCP-EVNT:S0: nexthop update oce for wc 10.11.1.10, 0x0 -> 0x23C10CF0 IP adj out of GigabitEthernet2/24, addr 10.11.1.10 23C10C80
2w3d: WCCP-EVNT:S0: track nexthop for wc 10.11.1.10 (OK)
2w3d: %WCCP-5-SERVICEFOUND: Service web-cache acquired on WCCP client 10.11.1.10
10CSW-LAN1(config)#
2w3d: WCCP-PKT:S0: Received HIA from 10.11.1.10, rcv_id:1
2w3d: WCCP-EVNT:S0: Building new router view
2w3d: WCCP-EVNT:S0: deallocate rtr_view (24 bytes)
2w3d: WCCP-EVNT:S0: allocate mask rtr_view (572 bytes)
2w3d: WCCP-EVNT:S0: copy orig info (540 bytes)
2w3d: WCCP-EVNT:S0: Assignment wait timer restarted, delay 50000
2w3d: WCCP-EVNT:S0: Built new router view: 1 routers, 1 usable WCCP clients, change # 2
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:2
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: setting up wc mask assignments
2w3d: WCCP-EVNT:S0: allocate current assign info (540 bytes)
2w3d: WCCP-EVNT:S0: set wc current assign info (540 bytes)
2w3d: WCCP-EVNT:S0: RA from 10.11.1.10 (id: 10.11.1.10), assignment key set to 10.11.1.10,3
2w3d: WCCP-EVNT:S0: Building new router view
2w3d: WCCP-EVNT:S0: reuse rtr_view (44 of 572 bytes)
2w3d: WCCP-EVNT:S0: copy blank current info
2w3d: WCCP-EVNT:S0: Assignment wait timer stopped
2w3d: WCCP-EVNT:S0: Built new router view: 1 routers, 1 usable WCCP clients, change # 2
2w3d: WCCP-PKT:S0: Received RA from 10.11.1.10, rcv_id:2
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: reuse wc orig mask info (540 bytes)
2w3d: WCCP-EVNT:S0: wc assignment validated
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:3
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: reuse wc orig mask info (540 bytes)
2w3d: WCCP-EVNT:S0: wc assignment validated
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:4
10CSW-LAN1(config)#
2w3d: %SEC-6-IPACCESSLOGP: list IRONPORT_GROUPLIST permitted udp 10.11.1.10(0) -> 10.11.1.9(0), 5 packets
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: reuse wc orig mask info (540 bytes)
2w3d: WCCP-EVNT:S0: wc assignment validated
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:5
2w3d: WCCP-EVNT:Process: Start V2 (138)
2w3d: WCCP-EVNT:Successfully opened UDP socket
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:router-id set (initialise) 0.0.0.0 => 10.11.1.9
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: allocate wc orig mask info (540 bytes)
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:1
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: reuse wc orig mask info (540 bytes)
2w3d: WCCP-EVNT:S0: HIA from 10.11.1.10 updated transmit interval to: 10000
2w3d: WCCP-EVNT:S0: HIA from 10.11.1.10 updated timer scaling factors to: 1 and 1
2w3d: WCCP-EVNT:S0: HIA from 10.11.1.10 updating group methods
2w3d: WCCP-EVNT:S0: HIA from 10.11.1.10 updating group timers
2w3d: WCCP-EVNT:S0: no srvc grp mask data to validate
2w3d: WCCP-EVNT:S0: created adjacency interest, 10.11.1.10
2w3d: WCCP-EVNT:S0: nexthop update oce for wc 10.11.1.10, 0x0 -> 0x23C10CF0 IP adj out of GigabitEthernet2/24, addr 10.11.1.10 23C10C80
2w3d: WCCP-EVNT:S0: track nexthop for wc 10.11.1.10 (OK)
2w3d: %WCCP-5-SERVICEFOUND: Service web-cache acquired on WCCP client 10.11.1.10
10CSW-LAN1(config)#
2w3d: WCCP-PKT:S0: Received HIA from 10.11.1.10, rcv_id:1
2w3d: WCCP-EVNT:S0: Building new router view
2w3d: WCCP-EVNT:S0: deallocate rtr_view (24 bytes)
2w3d: WCCP-EVNT:S0: allocate mask rtr_view (572 bytes)
2w3d: WCCP-EVNT:S0: copy orig info (540 bytes)
2w3d: WCCP-EVNT:S0: Assignment wait timer restarted, delay 50000
2w3d: WCCP-EVNT:S0: Built new router view: 1 routers, 1 usable WCCP clients, change # 2
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:2
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: setting up wc mask assignments
2w3d: WCCP-EVNT:S0: allocate current assign info (540 bytes)
2w3d: WCCP-EVNT:S0: set wc current assign info (540 bytes)
2w3d: WCCP-EVNT:S0: RA from 10.11.1.10 (id: 10.11.1.10), assignment key set to 10.11.1.10,3
2w3d: WCCP-EVNT:S0: Building new router view
2w3d: WCCP-EVNT:S0: reuse rtr_view (44 of 572 bytes)
2w3d: WCCP-EVNT:S0: copy blank current info
2w3d: WCCP-EVNT:S0: Assignment wait timer stopped
2w3d: WCCP-EVNT:S0: Built new router view: 1 routers, 1 usable WCCP clients, change # 2
2w3d: WCCP-PKT:S0: Received RA from 10.11.1.10, rcv_id:2
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: reuse wc orig mask info (540 bytes)
2w3d: WCCP-EVNT:S0: wc assignment validated
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:3
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: reuse wc orig mask info (540 bytes)
2w3d: WCCP-EVNT:S0: wc assignment validated
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:4
10CSW-LAN1(config)#
2w3d: %SEC-6-IPACCESSLOGP: list IRONPORT_GROUPLIST permitted udp 10.11.1.10(0) -> 10.11.1.9(0), 5 packets
10CSW-LAN1(config)#
2w3d: WCCP-EVNT:S0: updating wc orig assign info
2w3d: WCCP-EVNT:S0: reuse wc orig mask info (540 bytes)
2w3d: WCCP-EVNT:S0: wc assignment validated
2w3d: WCCP-PKT:S0: Sending ISY to 10.11.1.10, rcv_id:5
06-17-2012 10:18 PM
Dear,
Remove command ip wccp web-cache redirect out from SVI and put it under the egress interface (uplink, carrying traffic away from 4500)
Let me know the outcome please
Regards
Musab
---
Posted by WebUser Musab Kiani from Cisco Support Community App
06-17-2012 10:19 PM
Also please verify, if you manually configure the proxy address in browser, does it work??
---
Posted by WebUser Musab Kiani from Cisco Support Community App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: