Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

We have a few Catalysts4007 with 3 power supplies each. Is it ok that some of them turn their Fail-LED to red when i plug out the power cord and some dont?

Is it ok that some power supplies of our Catalyst 4007 switches turn their fail LED to red when i plug out the power cord and others don't? They are made by two different manufacturers: Sony, Japan and Ascom, Germany

1 REPLY
Anonymous
N/A

Re: We have a few Catalysts4007 with 3 power supplies each. Is i

if you can't plug all the power supplies, the supervisor will show the faulty status. This is default. YOu can see also thru sh system, in which it will indicate one of the power supply to be faulty and that cause the sup status to be faulty

112
Views
0
Helpful
1
Replies
CreatePlease to create content