What are default 'delay' values for various speed interfaces in 6509?
I have several 6509s with a mix of 10/100BaseTX, FX and 1000MB GBIC interface modules. When I am consoled into the MSFC and do a 'sh int vlan xx' the delay field on all vlans is the same - 10usec. I'm sure this is because the MSFC doesn't know which ports on the switch are associated with the vlans.
So what this does is create some unwanted routing through the 6509s because the delay values are all the same. I'd like to set the delay values on the vlans to more accurately match the port speed the vlans are attached to.
On an FE port of a 7206 router the delay value is 100usec, and an Ethernet port is dalay of 1000usec.
Should I use those same values on the 6509 MSFC to configure delay on the various vlans/ports?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...