I think you are asking whether turning on WRED will impact priority (LLQ) class -- the answer is it depends! It depends on what type of configuration you are using on the serial interface. Are you using the modular QoS command line interface to apply the QoS policy? It is possible to use the MQC to run WRED on a particular traffic class and not touch priority (LLQ) class. If you apply WRED on the interface rather than using the MQC to create classes, you could impact LLQ type traffic.
Post an example of the config I can assist further.
I am saying to enable it within the policy map for the particular class that you want to WRED. For example, if we want to do WRED on the class FTP only, just insert random-detect as shown below in your config. This assumes that you want to use the default settings for WRED. This configuration will have no impact on the traffic class that you have placed in LLQ (priority). Don't do WRED on the interface. I hope this helps!
random-detect <--- insert this command to WRED FTP
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.