What is the easiest and most graceful way to disconnect a call on a PRI?
I have a 4500 router with a PRI card in it. There are about 15 sites that we can call out through the PRI to. If I have a call up, I have been shutting down the D-channel (s0:23) to disconnect the call. However, if there are 2 calls going on at the same time, then using this method, both calls will be disconnected. How can I disconnect a single call on a PRI without shutting the D-channel down?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...