When you configure frame-relay traffic shaping using a map-class (as below), the mincir value determines the minimum value that the router will shape that PVC to ...
map-class frame-relay frShape
frame-relay cir 64000
frame-relay mincir 32000
frame-relay adaptive-shaping becn
frame-relay bc 8000
frame-relay be 16000
For example, with the above config, the router will attempt to shape the circuit at 64kbps. However, if it starts receiving BECNs from the frame-relay switch it is connected to, it will start reducing the rate at which it is transmitting data on that PVC (until the BECNs stop). The minimum rate to which it will drop the transmission is determined by the minCIR, which in the above case is 32kbps.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...