What is the maximum transfer rate of BVI interface?
I have a dedicated T3 between my two remote offices with a 3640 on one end and a flexwan on the other end.
For redundancy, I created a BVI bridge interface on the 3640. Currently I'm using TAR command to transfer data between these two sites and I'm getting about ~12GB /hr, but I was expecting to get about 15-18Gb/hr. Is the BVI interface my problem?
Re: What is the maximum transfer rate of BVI interface?
Take into account that in every packet, you have headers, footers, preambles, etc etc. There are quite a few factors to add into the mix, but even all those notwithstanding, you are not going to sustain at the full pipe's speed. Burst, yes...sustain, no. Signaling and clocking have to be taken into account as well.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...