Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Employee

What port is a device hanging from???

If I want to determine what port in a Cat 4006/4232 switch a device is hanging from; how do I do that? I see the mac address in the "sh arp" response. How do I associate that with a particular port number on a blade?

1 REPLY
New Member

Re: What port is a device hanging from???

I don't have a Cat 4006 to confirm this command is available, but here's what you can do with a Cat 6500.

I hope it helps. Let me know if the Cat 4000 is different.

------------------------------------------ snippette from session----------

M1_6500_C01 (enable) sho cam ?

agingtime Show cam aging time

count Showing cam total entries

dynamic Show dynamic cam entries

msfc Show cam Multilayer Switching Router info

permanent Show permanent cam entries

static Show static cam entries

system Show system cam entries

MAC address

M1_6500_C01 (enable) sho cam 08-00-20-c4-1c-a2

* = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.

X = Port Security Entry $ = Dot1x Security Entry

VLAN Dest MAC/Route Des [CoS] Destination Ports or VCs / [Protocol Type]

---- ------------------ ----- -------------------------------------------

38 08-00-20-c4-1c-a2 3/1 [ALL]

Total Matching CAM Entries Displayed =1

M1_6500_C01 (enable)

---------------------------- end of console output----------

215
Views
0
Helpful
1
Replies