Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

What's the command?

to get the serail number off my switches and routers. I had the impression that Show Ver was it but it only works on my 2950.

I have 2500, 2611, 3640, 3745, and 6509.

TIA

5 REPLIES
Gold

Re: What's the command?

"Show inventory" works on some Cisco devices too. (May need to have a recent IOS version running for this to work, though.)

Anonymous
N/A

Re: What's the command?

Apart from 6509 you should get serial numbers from remaining routers/switches. What IOS you are running ?

New Member

Re: What's the command?

I'm using 11.2 on our 2500's and on the newer equipment such as the 2611 I'm using 12.0 and higher.

New Member

Re: What's the command?

Try "show platform" for the 3745.

New Member

Re: What's the command?

Hi,

for modular routers try the command "sh diag" for modular switches try the command "sh module", this command will let u know the serial numbers of the modular cards, as far as my knowledge goes, there is no command to let u know the serial numbers of the devices, moreover the commands "sh diag", "sh module", will give the serial number of the Motherboard, please dont get confused.

-Sai.

187
Views
0
Helpful
5
Replies