Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

what`s wrong ?

Hey,

i have the following annoying problem in a lab i`m doing.

i have configured my cisco801 to dial with dialer1 b1 to isp and dialer2 b2 to another cisco 801 which only wait for the call ,his other b channel is not doing anything.

the problem is that i can`t ping from a computer connected to the first router to a computer behind the other.i can ping from&to both eth of the routers.

first router is doing nat over dialer1 to isp but not over dialer2 to the other cisco.

any suggestions ?

1 REPLY

Re: what`s wrong ?

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

118
Views
0
Helpful
1
Replies
CreatePlease to create content