What to command to use to show IP address

[malberttoo]

Gurus, I have a Catalyst 3560, and was wondering what command I could use to show the IP Address of the device plugged into a specific port?

Thanks!

[pkhatri]

Hi Mate,

Switches don't collect information on IP addresses plugged into a port. The only thing you can get is the MAC address of the device plugged into the port.

Hope that helps - pls rate the post if it does.

Paresh

[glen.grant]

If you have a switch that is non trunked sometimes you can ping the broadcast address of the subnet and then look in the arp table after you know the mac from looking in the mac-address-table .