Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

What to command to use to show IP address

Gurus, I have a Catalyst 3560, and was wondering what command I could use to show the IP Address of the device plugged into a specific port?

Thanks!

2 REPLIES
Purple

Re: What to command to use to show IP address

Hi Mate,

Switches don't collect information on IP addresses plugged into a port. The only thing you can get is the MAC address of the device plugged into the port.

Hope that helps - pls rate the post if it does.

Paresh

Purple

Re: What to command to use to show IP address

If you have a switch that is non trunked sometimes you can ping the broadcast address of the subnet and then look in the arp table after you know the mac from looking in the mac-address-table .

147
Views
10
Helpful
2
Replies
CreatePlease to create content