Re: When I log onto my 2811 router (IOS Ver 12.3(8)T8 it dumps m
There are a couple of things that can result in the session going directly into enable mode instead of into user mode. I think the most likely one is a configuration on the vty lines which specifies privilege level. I suggest that you check the configuration of the 2811 and look under the vty lines for privilege level 15. If it is there remove it and your sessions should start in user mode.
It is also possible that if you are using aaa to authenticate and authorize that the user ID you are using has been configured to automatically give enable access. But I am guessing that the issue is the privilege level on the vty lines.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...