when moving a serial interface (530 ) from a 7500 router to a 4000 router it doesnt work.
I'm trying to move a 530 serial interface from a Fast serial Interface processor an a 7500 router to a cisco 4500 router. when I move the cable the 4000's interface shows UP / UP, but does not respond to a ping. All the controll leads are showing up. the only differance I see int the interfaces are the 7500 uses CXBUS and the 4000 uses HD64570.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...