Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Which enable password is looking for?

I have local aaa setup on router and enabled on line aux 0.

The local user is on privilege 5.

After I modem into the router, try to go to enable mode, the router is not takeing any the normal enable secure password, nor the password setuo under line aux 0?

Which enable password it is looking for?

2 REPLIES
Bronze

Re: Which enable password is looking for?

If you set your aaa up for local authentication then you need to add a username xxxxx password pswrd command. This creates a user for auth which is what you have turned on.

Community Member

Re: Which enable password is looking for?

Thanks for the answer.

I did have the user created, and modem in router no problem, just can not go to the enable mode. (I have tried the password under enable secret, under line aux 0 and the password for the local user)

92
Views
0
Helpful
2
Replies
CreatePlease to create content