Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

which ieee 802.3 encapsulation is the default for cisco router?

which ieee 802.3 encapsulation is the default for cisco router?

And if i want my router to run over ethernet by using snap encapsulation ,which command should i used?

1 REPLY
Bronze

Re: which ieee 802.3 encapsulation is the default for cisco rout

ARPA is normally the default; "sh int" will tell you specifically what is being used. To use SNAP, use the command "encap snap".

172
Views
0
Helpful
1
Replies
CreatePlease login to create content