Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
Bronze

which "lane" command correct?

Dear all,

I have seen two types of commands to configure LEC on Atm lane modules.

"lane client 1 ELAN1" and "lane client ELAN1", in which for first command "1" is VLAN-id. Which is correct command?

Thanks in advance..

Regards...

Ashok.

With best regards... Ashok ----------- Pls kindly rate if helpful or answered your question.
1 REPLY
Bronze

Re: which "lane" command correct?

I think both of them are correct. The first one is used on a switch to bind a vlan to the ELAN. The second one is used on a router which can route between different ELANs configured under different sub-interfaces.

89
Views
0
Helpful
1
Replies
CreatePlease to create content