Which version of IP/FW 3DES IOS do I need for 3640 to enable static nat with route-maps? I have c3640-ik9o3s-mz.122-6.bin. It is not supported in this version.
Our 3640 works as a firewall. We have a couple of Nat translation entries:
2 dynamic ( one to internet, the other with overload on the route to the partner company in London)
We want to add static translations with the route map to allow a few internal hosts to access another company over the leased line (256Kb made of 4 channels of E1). They should be able to access internet at the same time.
I found the document describing my implementation needs: NAT - Ability to Use Route Maps with Static Translations. It lists Release 12.2(4)T as the first realise with the above feature. I am running 12.2(6)
When I try to enter the command:
ip nat inside source static mylocal-ip myglobal-ip route-map My-Map
it doesn't recognize the command.
Which software image do I need?
My show version output:
System image file is "flash:c3640-ik9o3s-mz.122-6.bin"
cisco 3640 (R4700) processor (revision 0x00) with 124928K/6144K bytes of memory.
Processor board ID 17651310
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0
Channelized E1, Version 1.0.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Primary Rate ISDN software, Version 1.1.
Basic Rate ISDN software, Version 1.1.
5 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
8 ISDN Basic Rate interface(s)
1 Channelized E1/PRI port(s)
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of non-volatile configuration memory.
24576K bytes of processor board System flash (Read/Write)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.