Hi,
I have just installed a supervisor III module on the Catalyst 5500. I did a sh test 1 and the result is as shown. Is it normal?
sh test 1
Module 1 : 0-port Supervisor III
Network Management Processor (NMP) Status: (. = Pass, F = Fail, U = Unknown)
ROM: . Flash-EEPROM: . Ser-EEPROM: . NVRAM: . MCP Comm: .
EARL III Status :
DisableIndexLearnTest: U
DontLearnTest: U
DisableNewLearnTest: U
ConditionalLearnTest: U
MonitorColorFloodTest: U
EarlTrapTest: U
StaticMacAndTypeTest: U
BadDvlanTest: U
BadBpduTest: U
IndexMatchTest: U
ProtocolTypeTest: U
IgmpTest: U
SourceMissTest: U
SourceModifiedTest: U
ArpaToArpaShortcutTest: U
ArpaToSnapShortcutTest: U
SnapToArpaShortcutTest: U
SnapToSnapShortcutTest: U
SoftwareShortcutTest: U
MulticastExpansionTest: U
DontShortcutTest: U
ShortcutTableFullTest: U
Line Card Diag Status for Module 1 (. = Pass, F = Fail, N = N/A)
CPU : . Sprom : . Bootcsum : . Archsum : .
RAM : . LTL : . CBL : N DPRAM : . SAMBA : N
Saints : . Pkt Bufs : . Repeater : N FLASH : .
Phoenix : . TrafficMeter: . UplinkSprom : . PhoenixSprom: .
MII Status:
Ports 1 2
-----------
SAINT/SAGE Status :
PHOENIX Port Status :
Ports 9 17 18 19 20 21 22
INBAND A->B B->A B->C C->B A->C C->A
------------------------------------------
. . . . . . .
Packet Buffer Status :
PHOENIX Packet Buffer Status :
Ports INBAND A<->B B<->C A<->C
------------------------------
. . . .
Loopback Status [Reported by Module 1] :
Ports 1 2 9
--------------
U U .
Thanks.