Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

why can not i format the flash card in standby GRP?

In a GSR12012, i tried to format the flash card in SEC-GRP, but can not be successful, the log was as follows:

format sec-slot1:

Format operation may take a while. Continue? [confirm]

Format operation will destroy all data in "sec-slot1:". Continue? [confirm]

%Error formatting sec-slot1: (Invalid device ID)

But when i inserted it into the PRI-GRP's slot1, the operation can be done. How did this happen?

2 REPLIES
Silver

Re: why can not i format the flash card in standby GRP?

Might be CSCdw60243 depending on the code you are running.

There is a workaround: use delete/squeeze commands instead of format

Hope this helps,

Don

New Member

Re: why can not i format the flash card in standby GRP?

i c. Tks

91
Views
0
Helpful
2
Replies