Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Why do it mean ?

DSZX#show interfaces

FastEthernet0/0 is up, line protocol is up

Hardware is AmdFE, address is 0007.0eeb.b9c0 (bia 0007.0eeb.b9c0)

Description: fast

Internet address is 10.0.0.1/24

MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,

reliability 255/255, txload 25/255, rxload 4/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Half-duplex, 10Mb/s, 100BaseTX/FX

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters never

Queueing strategy: fifo

Output queue 0/40, 30781 drops; input queue 0/75, 0 drops

5 minute input rate 182000 bits/sec, 263 packets/sec

5 minute output rate 1019000 bits/sec, 197 packets/sec

831974803 packets input, 1658917285 bytes

Received 33380932 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog

0 input packets with dribble condition detected

602551196 packets output, 2044222764 bytes, 6 underruns

28426 output errors, 136769844 collisions, 29 interface resets

0 babbles, 23 late collision, 30956616 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

Above it : Is there a problem network out of the fastethernet 0/1?

too much collisions .

1 REPLY
Silver

Re: Why do it mean ?

Definitely there is a problem in the fastethernet link. You have 22% collisions which is not normal. Also interface resets and deferred frames. Check if there is a duplex or speed mismatch with the other end equipment? This interface has half-duplex and 10mbps configured.

Check the ethernet cable, and if possible configure full duplex 100mbps on both ends of the link and check.

85
Views
0
Helpful
1
Replies