Why does the command "show banner" reboot the switch?
While applying banners on our Cisco Catalyst 5000 series switches, the command "show banner" afterwards reboots/resets the switch. Even after logging out, and logging back in the switch will still reboot after the "show banner" command. The switch however, keeps the new banner in the config, and it is displayed durning the next logon. They are all running the same version of code 6.3.4a. I have checked for hidden control characters that would cause the switch to reboot, but there does not seem to be any. Also, the banner is less than the 3,070 character limit.
Re: Why does the command "show banner" reboot the switch?
Thanks, that was my next stop. The only thing I could find was "Cisco Security Advisory: Cisco CatOS Telnet Buffer Vulnerability". But it says the problem was fixed in the version of code that were are running.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...